2. GPS Hardware Configuration
-W variants of the Smart Radio uses an
internal GPS antenna, so no hardware configuration is necessary. -J variants of
the Smart Radio include a GPS RF port on the casing. Please refer to the latest
Integration Guide availble in the online Technical Library
for details on the RF connector.
Related Articles
3. GPS Configuration
Generally speaking, it should not be necessary to configure the internal GPS receiver. However, there is a GPS receiver configuration page in the web GUI under network → GPS Configuration. Figure 1 shows a screenshot of the page. If you are using ...
1. Introduction to the Smart Radio GPS Usage and Configuration Guide
The purpose of this guide is to instruct the user on how to configure and view the status of the GPS receiver. GPS is an optional feature in Doodle Labs’ Smart Radios and is available in -W and -J hardware variants and when ordered with the -G order ...
Serial Interface Configuration
Serial Interface Configuration Start with one of the hardware setups in the section above. A generic setup is shown in Figure 1. Figure 1 – Generic UART hardware connection Configuring the UART port using the GUI The GUI is strictly for configuring ...
Smart Radio LTE Failover: Hardware Setup
Hardware Setup Fig. 2 shows the hardware setup used in this guide. Fig. 2 – Hardware Setup Of note is that ETH1 should be connected to the LTE Modem. Aside from that, the Smart Radio is setup for typical usage.
4. GPS Status
The GPS receiver’s status is shown in the Status → Overview webpage. An example output is shown in Figure 2. Figure 2 – GPS status It is also possible to remotely poll the GPS status using any of the methods described in the Remote Management Guide ...