3. Model Specific Configuration

3. Model Specific Configuration

The Wearable (and OEM) and Helix model variants have addition configuration options compared to the defaults discussed in the section above.

Wearable/OEM Variant (-K)
The Wearable/OEM variant of the Smart Radio includes a WiFi radio along with some additional features to make it ideal as a hand-held or wearable unit.

WiFi Radio (Wearable/OEM only)
Fig. 7 shows the Wireless Configuration page for the Wearable/OEM models. Radio 0 (above) refers to the WiFi radio and Radio 1 (below) refers to the Mesh Rider radio.
    • Related Articles

    • 1. Introduction to the Smart Radio Configuration Guide

      Introduction The purpose of this guide is to aid in the software configuration of the Smart Radio. This guide is organized as follows. 1.      Smart Radio Settings (For all models) 2.      Model Specific Configuration 3.      System Configuration ...
    • Low Latency C&C and Video Streaming with the Nvidia Jetson Nano: Smart Radio Configuration

      Smart Radio Configuration In this section, we describe simple steps to setup the Smart Radio for video streaming. If you are not sure how to make any of these configuration settings, then please consult the Smart Radio Configuration Guide. IP ...
    • 3. GPS Configuration

      Generally speaking, it should not be necessary to configure the internal GPS receiver. However, there is a GPS receiver configuration page in the web GUI under network → GPS Configuration. Figure 1 shows a screenshot of the page. If you are using ...
    • 2. GPS Hardware Configuration

      -W variants of the Smart Radio uses an internal GPS antenna, so no hardware configuration is necessary. -J variants of the Smart Radio include a GPS RF port on the casing. Please refer to the latest Integration Guide availble in the online Technical ...
    • Serial Interface Configuration

      Serial Interface Configuration Start with one of the hardware setups in the section above. A generic setup is shown in Figure 1. Figure 1 – Generic UART hardware connection Configuring the UART port using the GUI The GUI is strictly for configuring ...